Aliphatic Polyurethane Finish A Tough Cosmetic Finish Coatings For
Industry Industrial Spray Paint
-A two pack acrylic polyurethane finish giving excellent durability
and long term recoatability.
-High Volume Solids
-Pass the test of NORSOK M501
-VOC less than 250g/L
-A tough cosmetic finish
-For use in offshore structureenvironment,such as petrochemical
plants, chemical plants, power stations, bridges and industrial
－For marine engineering.
Typical Film Thickness
80 microns dry (111microns wet)
9m2/L at typical film thickness
Method of Application
|Tip size range|
|Air Spray||Tip size range||2.0-3.0mm|
|Brush/Roller||For small area only|
|Thinner||Not recommended. Use only in exceptional circumstances (volume 5%)|
|Induction Period||Not required|
|Overcoating Data Substrate Temperature|
|Min Max||Min Max||Min Max||Min Max|
|Storage||Store in cool and dry conditions. Well ventilate. Keep away from
hot and fire. Shelf Life: 12 months minimum at 25℃. Subject to
|Pack Size||Part A||23kg/17L in 20 L container|
|Part B||2.3kg/2.5L in 6 L container|
|Flash Point||Part A||Greater than 31℃|
|Part B||Greater than 28℃|
|Mixed paint||Greater than 31℃|
All surfaces to be coated should be clean, dry and free from
The primer surface should be dry free from all contamination and
725-S52-60must be applied within the overcoating intervals
specified (consult the relevantproduct data sheet).
Areas of breakdown, damage etc., should be prepared to the
specified standard (e.gSa2½(GB/T 8923.1-2011)or Abrasive Blasting,
or Power Tool Cleaning) and patchprimed prior to the application of
725-S52-60 should be applied over a recommended primer coating
scheme. The primer surface should be clean, dry and free from
contamination. Areas of breakdown, damage etc. should be prepared
to the specified standard (eg. Sa2.5) and primed prior to the
application of 725-S52-60.
725-S52-60may be applied directly over aged 725-S52-60 following
thorough fresh water washing and degreasing provided the coating to
be overcoated is in an intact and tightly adherent condition. Loose
or flaking coatings should be removed back to a firm edge and an
appropriate primer should be used to repair the area before
application of the full coat.
This product is not recommended for use in immersed conditions.
When applying 725-S52-60 by brush or roller, for some colors, Two
coats of 725-S52-60 may be required to give uniform coverage,
especially when applying 725-S52-60 over dark undercoats.
Apply in good weather. Temperature of the surface to be coated must
be least 3℃ above the dew point when the humidity is lower than
The dry time and overcoating interval may change according to the
Avoiding absorb the solvent steam and paint steam for long time.
Skin and eyes must avoid contacting the paint. Pay attention to
ventilate and fireproof when applying.
|The data in the sheet base on the information from the laboratory
and practice. The application may exceed the control, so we only
ensure our product quality. We own the right of the data sheet
modification without informing.|