Green Epoxy Zinc Yellow Primer Industrial Spray Paint
-A two pack epoxy primer contains zinc yellow anticorrosive
-VOC less than 300g/L
-For use at Aluminum Alloy.
-For use in all atmosphere areas
|Typical Film Thickness||100 microns dry (159microns wet)|
|Theoretical Coverage||6.3m2/L at typical film thickness|
|Method of Application|
|Tip size range|
|Air Spray||Tip size range||2.0-3.0mm|
|Brush/Roller||For small area only|
|Thinner||Not recommended. Use only in exceptional circumstances (volume 5%)|
|Overcoating Data Substrate Temperature|
|Min Max||MinMax||Min Max|
|725-H06-19||36h 14d||20h 7d||16h5d|
|725-H53-81||36h 14d||20h 7d||16h 5d|
|Storage||Store in cool and dry conditions. Well ventilate. Keep away from
hot and fire. Shelf Life: 12 months minimum at 25℃. Subject to
23.5kg/15L in 20 L container
|4.7kg/5L in 6L container|
|Flash Point||Part A||Greater than 31℃|
|Part B||Greater than 29℃|
|Mixed paint||Greater than 31℃|
Consult your Sunrui Representative for the systems best suited for
the surfaces to be protected.
All surfaces to be coated should be clean, dry and free from
Aluminum or light alloy
The surface should be solvent cleaned to keep clean, dry and free
from metal corrosion products.
The substrate should be cleaned gently by sand paper, and then
The areas to be repaired should be cleaned to metal by mechanical
method. Abrade the area immediately surrounding the repair to
provide a key for subsequent coating application. Overlap areas
should be kept to a minimum.
This product will not cure adequately below 5℃. For maximum
performance ambient curing temperature should be above 10℃.
Apply in good weather. Temperature of the surface to be coated must
be least 3℃ above the dew point when the humidity is lower than
In common with all epoxy base coatings, 725-H06-19 will exhibit
chalking of the firm on UV exposure.
The dry time and overcoating interval may change according to the
Avoiding absorb the solvent steam and paint steam for long time.
Skin and eyes must avoid contacting the paint. Pay attention to
ventilate and fireproof when applying.
|Duty statement||The data in the sheet base on the information from the laboratory
and practice. The application may exceed the control, so we only
ensure our product quality. We own the right of the data sheet
modification without informing.|